Mobile Garage Door Repair Service
When your garage door opens and closes on its own, it can be rather dangerous. That is because it could open or close when you do not want it to. It could just close on top of you while you are moving in or out. Worse yet, it could fall on top of one of your loved ones. You may be wondering why this is the case, at East Cobb, GA, we are here to tell you why this sometimes occurs and what you can do to prevent it.
Reasons that Your Garage Door Opens on Its Own
This will also interfere with your garage door and cause it to open or close without your attempting to do so.
This can be remedied by changing access code on your garage door opener.
This is something that should be trouble shot by a professional.
It is necessary to remove the wiring fro the button in order to do so.
The keypad should be removed from the opener for troubleshooting.
The wiring will need to be replaced.
It might be necessary to upgrade from 22” gauge wiring to 16” gauge. When it is too cold, it can sometimes affect the wiring of your sensors. Check for things, such as fraying that can eventually cause the wiring to be cut.
You Safety beam sensors may be damaged.
If you have two of the same type of garage door opener, you should remove the sensors from one opener, apply them to the other to determine if this is the problem.
The logic board may be damaged.
You should have the circuit board removed in order for a trained professional to troubleshoot the problem. You can troubleshoot on your own by removing the circuit board and applying it to another logic board to see if this resolves the problem.
The receive board might be defective.
The receive board should be replaced. Sometimes it is found inside the power head and sometimes is on the outside of the power head.
This means there is a receiver board that is defective
You can troubleshoot by placing the openers receiver board on another opener.
This wiring may have a short in it or be defective.
Follow the steps suggested for ‘defective receiver board’ to resolve the problem.
This is an easy fix, it could be as simple as replacing the old batteries with new ones. If this doesn’t resolve the problem, it may be necessary to replace the remote.
It will likely be necessary for you to have the access code to your remote reprogrammed. If the problem still exists, you could try another receiver to see if this is the fix you need.
You can replace your receiver or your transmitter with one that is on a different frequency. You will have to check your frequency on the receiver.
Apply the steps above for ‘CB radios causing interference’ to remedy the problem.
Apply the steps above for ‘CB radios causing interference’ to remedy the problem.
Try plugging the garage door opener into a different outlet to resolve the problem.
Apply the steps above for ‘Faulty garage door wiring’.
You may have never imagined that you would have to take care of your garage door in order to continue using it without an incident from occurring that could be of harm to you and your family. Yes, caring for your garage is a responsibility that shouldn’t be taken lightly. You should definitely make sure you know what you can expect when you hear strange sounds or when your garage is acting unusual. You certainly shouldn’t ignore it.
We want to do our part in helping you maintain a safe garage and that is why we are offering the following suggestions when you experience the problem with your garage opening and closing on its own.